CHINESE JOURNAL OF ENERGETIC MATERIALS
+高级检索
无氯TATB的合成工艺改进
作者:
作者单位:

中国工程物理研究院化工材料研究所,中国工程物理研究院化工材料研究所,中国工程物理研究院化工材料研究所,中国工程物理研究院化工材料研究所

作者简介:

黄靖伦(1974-),男,博士,主要从事含能材料合成研究。e-mail: jinglunhuang@163.com

通讯作者:

基金项目:

十二五预研项目(No. 00401010201) 


Improvement of Synthesis Technology of TATB Free from Chloride
Author:
Affiliation:

Institute of Chemical Materials,CAEP,Institute of Chemical Materials,CAEP,Institute of Chemical Materials,CAEP,Institute of Chemical Materials,CAEP

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    为解决TATB合成中氯离子杂质对产品的影响,研究了以间苯三酚为原料,经过硝化、烷基化和胺化合成无氯TATB的改进工艺。详细研究了反应试剂、物料配比、反应温度、反应浓度等对产物收率的影响,各步收率达到91%以上,并用核磁共振氢谱、碳谱和质谱等对TATB及中间体进行了结构表征。改进的工艺具有两个主要特点: 一是硝化反应中采用了硝酸铵-浓硫酸为硝化剂的新硝化体系,确定了硝化反应条件为n(间苯三酚)n(硝酸铵)=13.3,反应浓度为0.356 mol·L-1,反应温度≤10 ℃; 二是胺化反应中采用了绿色溶剂乙醇作为胺化反应介质。 

    Abstract:

    To avoid the influence of Cl- in 1,3,5-triamino-2,4,6-trinitrobeneze(TATB), the synthetic technology improvement of TATB without Cl- was studied starting from phoroglucinol (PG), which were three steps including nitration, alkylation and amination. The affecting factors such as reactant reagent, mole ratio of material, temperature and concentration of reaction were studied. The yield of each step reaction reaches up to 91%. The structures of TATB and its intermediates were identified by 1H NMR,13C NMR, and mass spectra. There are two special aspects in the improved technology: one is the new nitration agents NH4NO3/H2SO4, and other is usage of ethanol as the reaction solvent. The optimized nitration conditions are :molar ratio of PG to NH4NO3 13.3, reaction concentration 0.356 mol·L-1, temperature below 10 ℃. 

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

黄靖伦,张丽媛,马卿,等.无氯TATB的合成工艺改进[J].含能材料, 2012, 20(5):551-554. DOI:10.3969/j. issn.1006-9941.2012.05.007.
HUANG Jing-lun, ZHANG Li-yuan, MA Qing, et al. Improvement of Synthesis Technology of TATB Free from Chloride[J]. Chinese Journal of Energetic Materials, 2012, 20(5):551-554. DOI:10.3969/j. issn.1006-9941.2012.05.007.

复制
历史
  • 收稿日期: 2012-03-17
  • 最后修改日期: 2012-04-11
  • 录用日期: 2012-04-19
  • 在线发布日期: 2012-09-26
  • 出版日期: